Tools and Equipment
- A pair of scissors
- An oven
Bill of materials
As a side note, we did not use the entire tube of adhesive so the cost to make the product will not be as high as listed here.
Building procedures
- First we cut out the notebook cover into the shape that we needed for it to fit into the helmet
- Then we cut the pegs off the hairbrushes we had bought to use as pegs for the insert
- We then took the ones that measured about one centimeter and attached them to the insert with the plastic adhesive
- After all of the pegs were set we put the prototype in the oven to allow for the heat to cure the glue making it stronger