Jacob's Sketches
Andrew's Sketches
Hayden's Sketches
Decision Matrix
Final Design
This is a plastic insert, which goes in the top of a motorcycle helmet. There are small, 1/16th in. pegs on the top of the insert, whose job is to secure the insert by attaching into the helmet liner. On the other side of the insert, there are larger 1/8th in. pegs, whose job is to keep the insert and liner off the hair, allowing air to pass through the hair, while also not crushing the hair. There are also breaks in the design (i.e. it is not solid around the edges) which allow it to better conform to the shape of the interior of the helmet. This increases comfort of the helmet, as there insert will also fit better to the head of wearer.